|
The
curl vent part is labeled incorrectly and should be part
G24A because you've already used all of the G24Bs.
This
vent is very poorly represented in the kit. You can either
keep the motor unit molded to the deck as is or slice
this off and build a new one. In either case you will
need to modify the curl vent to the correct configuration.
Option
1:
- Modify
the curl vent as described in the
Curl Vent section of the Vent Overview.
- Glue
onto the port side of the existing vent with the curl
facing starboard.
Option
2:
- Slice
the molded vent motor off I10.
- Build
a left handed motor unit as described in the Motor
Unit section of the vent overview.
- Build
the curved vent from scrap plastic or sprue and glue
to the aft side of the vent.
- Modify
the curl vent as described in the Curl
Vent section of the Vent Overview.
- Glue
onto the port side of your new vent with the curl facing
starboard.
This
is the preferred method because you can glue the vent
back onto the deckhouse roof slightly forward of it's
present position to allow more space for the funnel pipes
and ladder.
To ensure that vents
53, 54 & 55 will fit into the space on the deck house roof
AND allow the funnel pipes and ladders space you will need to
make the following modification to the ducts...
Fashion new ducts
from the sprue tree filed square. the duct should be approx.
1.5mm square.
|
